Using Heat Gun To Remove Golf Grip Tape

Mineral spirits with fingernails for.

Using heat gun to remove golf grip tape. Apply a strip of grip tape approximately slightly shorter than the grip and extended about 14 inch over the butt end. It can be re-sharpened using a belt sander following the original contour. You can replace the razor blade with a hook blade but its not necessary.

Use a heat gun if available to warm up old grip tape on shaft and peel offIf no heat source is available peel off tape until the shaft is free of any tape. To Tape or Not to Tape. Using a heat gun helps to loosen the tape in the most stubborn cases.

Use the hooked blade to cut down the grip away from your body and remove old gripStep 2. Use a hair dryer or heat gun to heat the old tape. Cut the grips off and the tape.

Step 1 Heat the golf club you plan to remove the tape from with a heat gun. Apply one layer of regular masking tape on the club. Use the hooked blade to cut down the grip away from your body and remove old grip.

Two temperature settings 630 F and 1000 F. I just use a knife to remove it or sometimes use heat gun to loosen it then finger to slowly peel it off. Finally got around to reusing the shafts yesterday.

Remove backing install tape around the shaft and fold over end. It should take approximately 10 minutes to heat the shaft. When using an air compressor to slide your grips on your clubs its possible to get away without using tape.